The Classic Harmony RCA socket is the latest from KLE Innovations. Price to performance ration, it might be the best female chassis connector I have heard. This socket is designed on a low mass principle. The Copper/Silver contacts conduct better than 101% IACS, and are arranged in a superior geometry. Designed for a 10mm hole, but they will fit 25/64" to 7/16"(9.9mm-11.11mm), and a panel thickness up to 0.157"(4mm) with the washer or 0.217"(5.5mm) without. The terminals will accept up to 13ga wire without modification.
All warranty is factory direct: KLE.Innovations@gmail.com
Sold per pair as pictured.
Download factory installation guide
HERE or technical document
HERE
Also, please see KLE's reply to one of our queries:
What do you consider the best solder to use with the Perfect22 Harmony? Break-in time?
Re Solder… Eutectic solder is the best to use, like Cardas QE. If your solder is Cardas Quad Eutectic Solder, your all good.
Re Break-in time… Recommendations: depending on the audio system…
Burn-in Time: >300-500hrs
Re KLEI Harmony RCA Sockets… we thought that we would mention the following Soldering tips, which we hope are helpful :=)
Support/Technical Tips – KLEI Harmony RCA Socket… Soldering tips which I hope are helpful :=)
Re Tip when Soldering to the Signal Pin… gently place a small amount of pressure at either of the 2 spots (ie pointed to) to ensure that the Signal pin does not move upward during the Soldering process (ie due to Heat transfer from the soldering iron, during the Soldering process).
Re Is using Heatsink Pliers/Clips is always necessary?… I do, and like you I am careful, but if you can gently place a small amount of pressure at either of the 2 spots (ie pointed to below) to ensure that the Signal pin does not move upward during the Soldering process (ie due to Heat transfer from the soldering iron, during the Soldering process) then the Heatsink Pliers/Clips may not be necessary.
Thanks Keith Louis :=)
|
|
For more information please visit the product website. |
